Toggle menu
Canon EOS 20D CF Card Slot Replacement

Canon EOS 20D CF Card Slot Replacement

Jul 13th 2020

Canon EOS 20D CF Card Slot Replacement

  • 图片1

  • 图片2

  • Step 1 Remove The Eyepiece Cap

     

    • Pull up on both sides of the the eyepiece cap. It should come off with little pressure.

jQuery点击切换图片展示 tab切换展示

  • Step 2 Remove screws from under the eyepiece cap

     

  • Remove the two screws hidden under the viewfinder eyepiece cap.

jQuery点击切换图片展示 tab切换展示

  • 图片1

  • 图片2

  • 图片3

  • Step 3 Remove hidden screw and other visible screw

     

  • Peel off the rubber grip on the back by grasping one of the corners and pulling out.

  • Once removed, a hidden screw is revealed.

    • Remove both visible screws from the rear of the camera.

jQuery点击切换图片展示 tab切换展示

  • Step 4 Remove bottom screws

     

  • Remove both labeled screws from the bottom of the camera.

jQuery点击切换图片展示 tab切换展示

  • 图片1

  • 图片2

  • 图片3

  • Step 5 Lift and remove the rear panel

     

    • When lifting the panel, make sure not to lift it too high, since you'll run the risk of tearing the cable, or damaging the connector on the board.

  • Flip the lock on the flex cable connector up with a spudger. The front panel should pop off now that the cable has been disconnected.

  • When reassembling the device, make sure to insert the left side of the front panel first, since it has a small lip that needs to fit under the left part of the camera case.

jQuery点击切换图片展示 tab切换展示

  • 图片1

  • 图片2

  • 图片3

  • Step 6 Disconnect all the labeled cables

     

  • Disconnect all the labeled connectors by opening their latches. Remove the flex cable that connects the logic board to the secondary control board.

  • The Super AMOLED display on our 46 mm version has a diameter of 1.3" (33 mm). The vertical and horizontal max resolution is 360 pixels.

    • Disconnect the two hidden connectors under the top connector labeled in pink. Disconnect the third hidden connector.

jQuery点击切换图片展示 tab切换展示

  • 图片1

  • 图片2

  • Step 7 Remove the secondary control board

     

  • Remove the three screws from the edges of the board.

  • Flip the board up and out so that the ground connection can be unscrewed.

jQuery点击切换图片展示 tab切换展示

  • 图片1

  • 图片2

  • 图片3

  • Step 8 CF Card Slot

     

    • Open the connector for the CF slot.Remove the CF slot.

    Remove the two screws holding the top of the CF slot in place.

    Remove the one last screw holding the CF slot in on the bottom.