Canon EOS 20D Rear Case Replacement

Canon EOS 20D Rear Case Replacement

Jul 13th 2020

Canon EOS 20D Rear Case Replacement
  • 图片1

  • 图片2

  • Step 1 Remove The Eyepiece Cap

     

  • Pull up on both sides of the the eyepiece cap. It should come off with little pressure.

jQuery点击切换图片展示 tab切换展示
  • Step 2 Remove screws from under the eyepiece cap

     

  • Remove the two screws hidden under the viewfinder eyepiece cap.

jQuery点击切换图片展示 tab切换展示
  • 图片1

  • 图片2

  • 图片3

  • Step 3 Remove hidden screw and other visible screw

     

  • Peel off the rubber grip on the back by grasping one of the corners and pulling out.

  • Once removed, a hidden screw is revealed.

  • Remove both visible screws from the rear of the camera.

jQuery点击切换图片展示 tab切换展示
  • Step 4 Remove bottom screws

     

  • Remove both labeled screws from the bottom of the camera.

jQuery点击切换图片展示 tab切换展示
  • 图片1

  • 图片2

  • 图片3

  • Step 5 Lift and remove the rear panel

     

  • When lifting the panel, make sure not to lift it too high, since you'll run the risk of tearing the cable, or damaging the connector on the board.

  • Flip the lock on the flex cable connector up with a spudger. The front panel should pop off now that the cable has been disconnected.

  • When reassembling the device, make sure to insert the left side of the front panel first, since it has a small lip that needs to fit under the left part of the camera case.